Canine Early Pregnancy Relaxin Rapid Test Kit
Is a sandwich lateral flow immunochromatographic assay for the qualitative detection of early pregnancy factor in dog’s serum.
Assay Time: 5-10 min
Sample: Secretions or serum

【Parameter】
Principle
|
Sandwich lateral flow immunochromatographic assay
|
Testing time
|
5-10 minutes
|
Packing content
|
-10×foil pouches, each containing one cassette, one pipette and a desiccant
-10×centrifugal tubes
-10×Micro-pipette 2 (5μL)
-10×assay buffer
-Product Manual
|
Storage
|
Room temperature (2-30°C)
|
Caution
|
-All reagents must be at room temperature before running the assay.
-Do not remove test cassette from its pouch until immediately before use.
-Do not use the test beyond its expiration date.
-The components in this kit have been quality control tested as standard batch unit. Do not mix components from different lot numbers.
-All specimens are of potential infection. It must be strictly treated according to the rules and regulations by local states.
|
【PRINCIPLE】
Early Pregnancy Rapid (RLN) Test Kit is based on sandwich lateral flow immunochromatographic assay. The test device has a testing window. The testing window has an invisible T (test) zone and C (control) zone. When sample is applied into the sample hole on the device, the liquid will laterally flow on the surface of the test strip. If there is enough Early Pregnancy Rapid Test in the sample, a visible T band will appear. The C band should always appear after a sample is applied, indicating a valid result. By this means, the device can accurately indicate the presence of Early Pregnancy Rapid Test in the sample.
【Directions For Use】
- Collect dog’s blood 1ml Centrifugal: 1500 speed/minute. (If samples don’t need to be test immediately, then shall be kept in cold storage; if samples are kept over 24 hours, then shall be cryopreservation)
- Take out the cassette from the foil pouch and place it horizontally.
- Use Pipette 2 gradually drip serum, plasma or whole blood(blow 5μL) into the sample hole.
- Wait for the sample to be completely absorbed into the sample hole.
- Then add 2 drops of the assay buffer. Wait for 5-10 minutes and interpret results. The result is considered invalid after 10 minutes.

【Result】
-Positive (+): The presence of both “C” line and zone “T” line, no matter T line is clear or vague.
-Negative (-): Only clear C line appear. No T line.
-Invalid: No colored line appears in C zone. No matter if T line appears.

【Product Display】
